There is very important for the Switch And Socket when you decoration . If there is an unreasonable layout, there is no way to modify the interior decoration, and it will bring great inconvenience to life. Below small presentation room switches and sockets and interior layout considerations as you SWITCH SOCKET replacement points.
Indoor switch socket layout considerations
1, the general power switch socket installation height between 110cm-150cm, this can be set according to the height of the family members, if the height is similar, the recommended spacing of the switch socket does not exceed 5mm.
2. The common power socket is about 35cm from the ground, and the height of the air conditioning socket from the ground is generally between 170cm-210cm.
3, refrigerators and sockets can be located on both sides of the refrigerator, from the ground to insert high 120cm or about 60cm into the ground.
4. The switch sockets on both sides of the bed should be flat, preferably above the nightstand, 80cm from the ground.
5, the outlet of the water heater should be located on the right side of the appliance to facilitate operation, but be careful not to over-high.
6, the switch socket on the balcony more than 150cm from the ground, to avoid the sun and rain.
Indoor switch socket replacement points
1, cut off the power
Switch off the power before replacing the socket, and select the new socket with the current limit of 25 A.
2, disassemble
Use screws to remove the socket. If the cover is not easy to remove, use a blade to carefully lift the cover. After removing the fixed screws, remove the socket from the cable box and carefully remove the wires.
3, wiring
Connect the new socket to the wire and fix it with screws. The neutral line is blue N, the fire line is red or yellow L, and the ground line is yellow and green. After the connection, tighten the screws.
4, install
Carefully fold the socket or wire in the wire box, and then tighten the screw of the wire box. When installing, check whether the wire box is stable. It is best to fix the cover with screws and turn on the power.
5, inspection
For safety reasons, the electric pen can be used for electro inspection after it is installed. The pen needs to contact each socket. The front bright is the negative (neutral line position), and the bright rear end is the positive (fire line position). When the power is properly connected, the right side of the socket should be a zero line and the right side should be a live line.
Summary of the editor: Regarding the layout of indoor switch sockets and the key points of indoor switch sockets replacement, I hope to be helpful to everyone. Want to learn more related knowledge can focus on this site information.
Edited by Foshan Langzhi